Forms

At this point, I normally wouldn't make a post about cutting out the forms, but I tried a new way of doing it.

I tried cutting them out on a scroll saw, in order to cut closer to the line than I can with the jigsaw. This is 3/4" MDF, and the scroll saw struggles with it a little, but it definitely made sanding to the line easier. If I had the skill/guts, I could cut right to the line with the scroll saw. It was also a good way to cut the "split" forms apart. Speaking of which, I managed to lose one half of form 17, and had to make another one by tracing from the other side